Nexus 21 Transcend Pro Surface, Руководство по установке

Страница: 15 / 20

15
How to Set a Lower Limit
Only the Lower Limit can be set on the Transcend Pro Surface, however it must be able to fully travel with no
obstructions below it. This is because the Mount resets in the lowest position and will be unable to reset if it is
obstructed.
To set a Lower Limit follow the steps listed below:
1. Press the DOWN button on the Wired Backup Switch or Remote Control.
2. Once the Mount reaches your desired position, press the UP button to STOP the Mount.
3. Plug the Height Limit Insert into Port A2 on the Control Box if you are using IR Controls. If you are using RF Controls,
plug the Height Limit Insert into the available RJ45 Port on the RF Receiver.
OR