Nexus 21 L-45, Руководство по установке

Страница: 15 / 24

15
Step 12: Attach the Screen Back Plate to the Screen
Support Bracket.
Raise the lift to fully expose the Screen
Support Bracket. Using (4) 3/8 – 16 x ¾” BHMS attach the
Screen Back Plate to the Screen Support Bracket. To
determine which set of holes to use, measure the upper
bolt hole on the back of the TV to the top of the TV, this
measurement should be relatively the same from the top
of the Screen Support Bracket to the bottom of the Top
Plate.
NOTE: The bent tabs on the Screen Back Plate indicate
the top of the plate.
Step 13:
How to Install the Tapered Pins:
You will be screwing the Tapered Pins into the UNDERSIDE of your cabinet lid, and they will hang down and
drop into the two holes in the Top Plate (Part #8).
Step 13: Before installing the Tapered Pins, position the Cabinet Lid.
With the TV and the Lift System in the
fully DOWN position, set the Cabinet Lid in place. It will not be attached at this point, so move it around on the
Top Plate, making sure it fits centered in the cabinet opening.
Step 14: Run the Lift System up and down with the Cabinet Lid sitting on top, but not attached. Without
bumping the Cabinet Lid out of place, use the Remote Control Handset to send the Lift System up and down.
Make sure that when the Lift comes down, the Cabinet Lid drops into the proper position relative to your
cabinet opening.
NOTE: You may want to temporally tape your lid, to
prevent the lid from shifting.
Step 15: Mark the spots for the Tapered Pins. Again,
without bumping the Cabinet Lid out of place, run the
Lift System all the way UP, with the Cabinet Lid sitting
on top. Look at the UNDERSIDE of the Top Plate, find
the two holes, and use a felt-tip pen or a pencil to mark
the position of the holes on the underside surface of the
Cabinet Lid
.
NOTE: Make sure the nuts on the bottom side of the Top Plate are hand tight and centered before you mark
your lid.