Nexus 21 L-23S, Руководство по установке

Страница: 14 / 24

14
Step 12: Add the Monitor Hanger (Part #5). Lay the
Monitor Hanger on top of the Monitor Adapter Plate.
It should be oriented with the flat side down, and the
top surface (the edge that has 4 mounting holes for
the top plate) facing “up”, toward the top of the TV.
Line up the smaller slots with the threaded studs on
your Monitor Adapter Plate.
Step 13a: Position the Monitor Hanger. Slide the
Monitor Hanger up, so the top edge (the edge that
has 4 mounting holes for the top plate) sits ¼” to ½”
HIGHER than the top of the TV.
NOTE: This step determines how much of a “gap” will
exist between your lid piece and your TV. The smaller
the gap, the better it will look. If you are using a
hinged-style lid, mount your TV as high as possible on
the Monitor Hanger. This will insure that the Hinged-
Top Guides, which will be installed in Step 15, are not
mounted too high above your TV and give the
installation an awkward look.
Step 13b: Fasten the Monitor Hanger to the
Monitor Adapter Plate. Use the four ¼” Flat
Washers, and the four 6mm Hex Nyloc Nuts, placing
them onto the threaded studs from the Monitor
Adapter Plate.
DO NOT OVER TIGHTEN.
Step 14: Run the TV Lift UP. Before proceeding, check
the position of the pigtail cable.
BE SURE THE PIGTAIL
CABLE IS STILL PROPERLY SEATED IN THE SQUARE CUT
OUT CHANNEL ON THE TOP OF THE LIFT COLUMN (as
described previously described in Step 2).
The Monitor
Hanger will press tight to the Lift Column, so before
going on to the next step you will need to gently hold
the Motor Cable plug to one side to make mounting the
Monitor Hanger easier.
TIP: Gently pull the Motor Cable
to the side that is closest to where you plan to mount
the Control Box (Part #6).