Next PXL118 User’s Manual
www.next-proaudio.com
- 3 -
V052013
_______________________________________________________________
Rigging and suspension
WARNING: DO NOT SUSPEND PXL118 Sub1.
In the NEXT PX system only the
PXL118 Sub 2, PXH64 and PXA8000 are designed to be suspended, PXL118 Sub 1 was not
designed having suspended use in mind.
Before rigging or suspending any NEXT PX system component
,
inspect all components
and all hardware for any signs of damage or missing parts. If you find any damaged,
corroded or deformed parts, do not use them, replace them immediately. Do not use
hardware that isn’t load rated or that its rating is not enough to handle the system’s weight
with a good safety factor. Don’t forget that the hardware won’t just hold the systems weight.
It has to be sturdy enough to handle dynamic forces like winds without any part
deformation.
NEXT PX system installation should only be carried out by qualified personnel. Always
use adequate protective clothing and equipment to prevent possible injuries. Isolate the
surrounding area during installation and operation, to prevent general public presence near
the systems. Also, be sure you understand all local and national regulations regarding
equipment installation. Failure to comply with these instructions may result on injury or
death.
UNPACKING
Each
NEXT
PX system component is built in Europe (Portugal) by NEXT-Proaudio, to
the highest standard and thoroughly inspected before it leaves the factory. When unpacking
the NEXT PXL118, examine it carefully for any signs of possible transit damage and inform
your dealer immediately if any such damage is found.
It is suggested that you retain the original packaging so that the system can be
repacked in the future if necessary. Please note that NEXT-Proaudio and its authorized
distributors cannot accept any responsibility for damage to any returned product through the
use of non-approved packaging.
PXL118
OVERVIEW
The NEXT PXL118 subwoofer element is part of the PX system
1
. There are two
different enclosures named PXL118 Sub 1 and PXL118 Sub 2. This is because of their
configuration within the system. PXL118 Sub 1 is placed directly on the floor, and Sub 2 is
placed on top of Sub 1.
The PXL118 makes use of a hybrid design to achieve a high maximum sound pressure
while producing a deep low bass well below 50 Hz. Even under maximum load the impulse
response accuracy is striking. It has a rich and punchy sound and was specifically designed
to match the PXH64 mid/hi element extending its’ frequency response down to 50Hz. It’s
1
Refer to PXH64 user manual for a full description of PX System.
