1.The fire is ready for use through controlling the
switches.
NOTE:
The switches will look like the diagram as show. It is
important to be aware that switches must be turned on
in the correct sequenceas below:
‘A’ must be on prior to switching on ‘B’ to get cool
wind.
‘A & B’ must be on prior to switching on ‘C’ to operate
at 1Kw.
‘A & B & C’ must be on prior to switching on ‘D’ to
operate at 2Kw.
Switching off ‘A’ will disable ‘B & C & D’& "Brightness"
• Heating Appliance Settings
NOTE:
CAUTION:
1. Open the door of the engine.
• Before undertaking any maintenance or cleaning, unplug or disconnect fire from the socket outlet.
STEP ONE
ILLUMINATED PEBBLE BED BULB REPLACEMENT
Bulbs have a limited life span and will require replacing as they expire.
• Bulbs can be very hot, handle with care. Allow bulbs to cool before attempting to replace.
Timber Dust with a soft, dry cloth. If necessary, polish with furniture wax. Avoid silicone based spray polishes.
Note: sunlight affects timber, giving a natural deepening colour. This ‘mellowing’ is traditionally
add to the beauty of wooden furniture
MDF Clean with a lightly dampened cloth or a non-abrasive domestic cleanser.
To reduce dust build up, the fan area must be regularly vacuum cleaned through the grill, with a soft brush nozzle,
the fire has been switched off and is cool.
• CARE
Metal The surfaces should be cleaned with a lightly dampened cloth. Abrasive creams should not be used.
FAN UNIT (HEATER)
The fan heater has a thermostatic cut-out to prevent overheating. It should reset automatically after the appliance
switched off and on again at the mains. Allow 15 minutes to cool.
When in use, the fan will emit a faintly audible ‘hum’. This is a normal feature of fan assisted air movement.
STEP FIVE
MAINTENANCE