Nexgrill 820-0062H, Руководство пользователя

Страница: 17 / 24

16
To remove the burners and cross channel for cleaning:
1. Locate the burner screws at the rear of the firebox and the cross channel screws at the front of the firebox.
2. Remove the four screws.
3. Lift the burners out of the firebox.
4. Disassemble the cross channel by removing the ignitor pin screws attached.
BURNERS – Extreme care should be taken when removing and replacing a burner. It must be correctly centred on the orifice
before any attempt is made to relight the grill. Frequency of cleaning will depend on how often you use the grill.
Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the valve panel, thereby
damaging the grill and making it unsafe to operate. Before cleaning, make sure the gas supply is CLOSED and control knobs
are in the ”OFF” (
 ) position and the burners have cooled.
CLEANING
STEP 1
To clean the grill burners:
1. Clean the exterior of the burner with a wire brush. Use a metal
scraper for stubborn stains or debris.
2. Clear clogged ports with a straightened paper clip. Never use
a wooden toothpick as it may break off and clog the port.
3. Check and clean burners / venturi tubes for insects and insect
nests. A clogged tube can lead to a fire beneath, and behind
the main control panel.
STEP 2
WHEN TO LOOK FOR SPIDERS
You should inspect the burners at least twice a year or immediately after any of the following conditions occur:
1. Gas can be smelled in conjunction with burner flames appearing yellow.
2. The grill does not reach temperature.
3. The grill heats unevenly.
4. The burners make popping noises.