Nexgrill 730-0371, Инструкции по сборке и эксплуатации

Страница: 24 / 34

PROBLEM SOLUTION
When I light the grill it does not flame
immediately.
--Make sure you have turn on the gas
--Make sure it has spark while you are trying to ignite
the burner.
--Push in for approximately 5 second before to turn
and ignite the grill.
--Make sure your burner is clean.
Regulator makes noise. --Vent hose on the regulator may be plugged or
regulator may be faulty.
--Ensure the vent hole on the regulator is not
obstructed. Clear the hole, close the gas control
valves. Wait ten minutes and re-start.
--Check your flames for proper performance if the
flames are not correct replace regulator.
Full size cover does not fit the grill. --Cover may be incorrect for your grill. It may be a
tight fit. Ensure the cover correct length for your
grill. Measure it left to right. Compare to the grill’s
measurement.
--Compare the location and size of the hood portion
of the cover to your grill.
--Spread the cover and allow it to relax, preferably in
warm sunlight or in a warm room.
--For grill with a side shelf bunch the cover like a
sock, put on left to right.
Grill only heats to 200-300 degrees. --Ensure the temperature gauge is functioning
properly. Hold a flame to the probe or compare the
grill gauge to an oven thermometer place in the
grill.
--Ensure correct start procedure. Prior to lighting grill,
the gas control knobs should be off. The propane
bottle should be off. If not, wait 15 minutes. Turn
tank all the way on.. Turn left burner to ignite, wait
5 seconds ignite. Repeat for additional burners.
--Check all gas connections for leaks with bubble
test. If leaks are found, replace the part or tighten
the fitting.
--If it is a natural gas grill, ensure there is proper
pressure to the grill. Refer to the user manual.
Example: Gas line stubbed off o pool heater may
exhibit deference in pressure.
TROUBLE SHOOTING
I15Y06N-1
23