GRILL LIGHTING INSTRUCTIONS
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then
the burner can be match lit.
Lighting rod-Here is your instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the coils on the
end of the extension rod and hold next to the burner to
ignite. (see reference Pg)
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Insert a lit match attached to tight
lighting rod or lighter through the cooking
grids to the burner.(see next page) Press the control
knob and rotate left to the HI setting, continue to press
the knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4 seconds
turn the knob off, wait 5 minutes and try again.
WARNING: IMPORTANT!
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be
used. Never substitute regulators for those supplied
with the grill. If a replacement is necessary, contact
the factory for proper replacement.
Screw the regulator (type QCC1) onto the tank. Leak
check the hose and regulator connections with a soap
and water solution before operating the grill.
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your stainless steel grill has an exclusive patented
built-in ignition. The igniter is built in to the valve. To
ignite each burner simply push and turn the control
knobs to the HI setting, you will hear the valve click as
it sends a spark to the pilot flame. If the burner does
not light wait 5 minutes for any excess gas to
dissipate and then retry.
FLAME CHARACTERISTICS
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however,
variations in the local gas supply may take minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of these
conditions exist call our customer service line. If the
flame is yellow, it indicates insufficient air. If the flame
is noisy and tends to lift away from the burner, it
indicates too much air.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1-866-984-7455
15
