Copyright © 2018 NEXCOM International Co., Ltd. All Rights Reserved.
28
NEX 614A User Manual
Chapter 3: BIOS Setup
NCT6106D Super IO Configuration
This section is used to configure serial ports 1 to 4 and the digital I/O port.
Super IO Chip
Displays the Super I/O chip used on the board.
WatchDog Count Mode
Configures the watchdog timing in seconds or minutes.
Deep S5 Support
Enables or disables deep S5 support.
Advanced
Version 2.18.1263. Copyright (C) 2017 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2017 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Parameters of Serial Port
1
NCT6106D Super IO Configuration
Super IO Chip
Serial Port 1 Configuration
Serial Port 2 Configuration
Serial Port 3 Configuration
Serial Port 4 Configuration
Digital I/O Configuration
WatchDog Count Mode
WatchDog TimeOut Value
Deep S5 Support
NCT6106D
[Second]
0
[Disabled]
Serial Port 1 Configuration
Serial Port
Enables or disables the serial port.
Device Settings
Displays the IO address and IRQ of serial port 1.
Change Settings
Selects an optimal setting for the Super IO device.
COM Mode Select
Configures the serial port mode to RS232, RS485 Half Duplex or RS485/
RS422 Full Duplex.
Advanced
Version 2.18.1263. Copyright (C) 2017 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2017 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable or Disable Serial Port
(COM)
Serial Port 1 Configuration
Serial Port
Device Settings
Change Settings
COM Mode Select
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
[RS232]
