ZIS-104
Indoor siren
TECHNICAL DATA
Power source
230V 50Hz
Backup battery
3.7V DC, 720 mAh
Frequency
Z-Wave (868.42 MHz)
Range
up to 30 m
Alarm signal
95dB at 1 metre
Operating temperature
-10°C to +50 °C >95% RH
IP rating
Indoor use
Dimensions (Ø x D)
80 x 32 mm excl. contact
ENGLISH
NEXA AB, DATAVÄGEN 37B, SE-436 32 ASKIM, SWEDEN
[email protected] | www.nexa.se
SAFETY AND INFORMATION
Range indoors:
up to 30 m (optimal conditions). The range is
very dependent on the local conditions, for example, if there are
metals in the vicinity. For example, the thin metal coating in energy
glass with low emissivity has a negative influence on the range
of the radio signals. There may be restrictions on the use of the
unit outside the EU. If appropriate, you should check that the unit
complies with local regulations.
Life-support equipment: Never use Nexa products for life-support
equipment or other devices where faults or interference could have
life-threatening consequences.
Interference: All wireless units can suffer from interference that can
affect the performance and range. For this reason, the minimum
distance between two receivers should be at least 50 cm
Repair:
Do not attempt to repair the product. It does not contain
any repairable parts.
Waterproofing: The product is not waterproof. Make sure it is dry
at all times. Damp causes the electronics inside to corrode and this
could lead to short-circuiting, faults and a risk for electric shocks.
Cleaning: Clean the product with a dry cloth. Do not use chemicals,
solvents or strong cleaning agents.
Environment: Do not expose the product to intense heat or cold,
because it could damage or shorten the service life of the electric
circuits.
The ZIS-104 is a Z-Wave Plus indoor siren that can be activated
from a Nexa Bridge or other control device with Z-Wave
certification. The siren uses a 230V power supply and has a built-in
battery backup.
SAFETY
Read through the entire instruction first. Engage a professional if so
required. Nexa cannot be held liable if the product is used for any
purpose other than the one for which it is designed, or if there is
failure to comply with the instruction.
INSTALLATION
The siren is a plug-in model and no installation is required. All you
need to do is connect it to the Z-Wave network.
CONNECT TO A Z-WAVE NETWORK
Inclusion:
1. Put the Z-Wave controller in exclusion mode (see the manual for
the controller)
2. Press the reset button 3 times within 1.5 seconds. The reset
button flashes when inclusion starts.
Exclusion:
1. Put the Z-Wave controller in exclusion mode (see the manual for
the controller)
2. Press the reset button 3 times within 1.5 seconds.
3. The reset button flashes 6 times when exclusion is complete.
FACTORY RESET
1. Hold down the reset button for at least 10 seconds.
2. The LED indicator flashes 2 seconds when resetting is complete.
POWER OUTAGE
The siren runs for up to 4 hours on the built-in backup battery in the
event of a power outage.
EXTENDED Z-WAVE CONFIGURATION
Can be found under the product at www.nexa.se
PA system
LED ring
flashes in the
event of an
alarm
Reset button
use the tool
supplied to
press the
reset button
