Newworld NW-100GT, Руководство пользователя и инструкция по установке

Страница: 23 / 32

INSTALLATION INSTRUCTIONS - GAS
Fitting the splashback (if applicable)
Fitting the towel rail (if applicable)
• On the towel rail there are two hole,
top (A) and bottom (B), these holes
have corresponding holes on the
fascia at each end.
• The screw for the top hole (A), must
be screwed into the supplied adaptor,
where as the remaining screw just
goes through the bottom hole (B).
Both screws are M6 screws. Using
the allen key provided, tighten the
screws making sure that the towel
rail is flush to the fascia, but not
over tightened.
• Ensure the appliance is raised
to a height of 915mm or above
using adjusting feet (A) before
beginning.
• Open the appliance doors and-
loosen screw (C), do not remove
the screw entirely. If your appli-
ance has a storage drawer at the
bottom, you access thescrews
through holes located at the
base of the drawer after lifting
the mat.
• Fit plinth (B) and secure using
screw (C).
• Loosely fit screw A and nut B
into hole 1 at both ends of the
rear surface of the appliance.
• Locate fitted screw A through
the slots in both of themetal
splashback plates.
• Tighten screw A and nut B.
• Now locate and tighten screw C
and nut D through hole (2) at
both ends of the rear surface of
the appliance. Make sure that
the splashback is securely at-
tached, but avoid over tighten-
ing.
Fitting the plinth (if applicable)