Newtons4th PPA45 Series, Руководство для стартапов, Страница: 22 / 127

PPA45xx Quick User Guide
Page 21
Transformer Mode
Large power transformers operate at very low power
factor (<0.01) and the phase accuracy is critical to
measure the losses. Power transformer application
mode sets the configuration options to the optimum
for phase accuracy e.g. AC+DC coupling range lock
across phases. The temperature can be monitored at
the same time by connecting a suitable temperature
sensor to the “torque” BNC input
Default Settings
All default parameters will be selected when “ENTER”
is pressed
Temperature
Temperature mode can be disabled or selected to
measure ⁰C or ⁰F via a suitable temperature sensor
connected to the “Torque” BNC input
Standby Power
In order to minimise standby power, some devices
operate in a “dormant” mode whereby power is only
drawn from the supply when needed. These devices
draw very little current for most of the time and then
draw a larger current for a single cycle to charge a
reservoir capacitor. This pattern is repeated on an
irregular basis. Most of the power consumed by
devices in this mode is taken in the periodic higher
current cycles so to accurately measure the power
drawn by these devices; the instrument synchronises
to the power frequency for the analysis but extends
the measurement window to the irregular period of
higher energy pulses. Because the instrument
samples in true real time without any gaps, no data is
missed and every power cycle is captured. It is
important that ranging is set to manual or up only
autoranging so that the power cycles are not missed
while ranging
Default Settings
All default parameters will be selected when “ENTER”
is pressed
Low Frequency Select “On” or “Off” if low frequency filter is required
Calibration
This mode is used when calibrating the instrument
with N4L software
Default AC Settings Select to calibrate AC
Default DC Settings Select to calibrate DC
Frequency Filter
Frequency synchronisation for calibration gives more
accuracy at low levels, applies to AC only