NewTek NDI HX PTZ3, Руководство по эксплуатации

Страница: 19 / 66

Page | 19
Controls in the Network Settings section will be familiar to anyone who has connected a computer or mobile
device to a network, and thus require little explanation.
Typically, your network will be configured to automatically supply IP addresses to devices you connect to it
by means of a DHCP server.
Your camera’s IP Address resolution method is set to Dynamic by default, to take
advantage of this scheme. To assign a static IP address, change the IP Address setting to Manual, enter a new
IP Address , and click Apply (changes will not take effect until Apply is clicked).
NOTE: Should the default IP Address mode (Dynamic) fail to provide a usable IP address within a minute or
two of powering up
– as when an active DHCP server is not found on the network – PTZ3 will automatically
switch to Manual mode and attempt to connect using a static IP address. The default IP address is
192.168.100.168.
1.11.2
MULTICAST
FIGURE 20
Enable Multicast to transmit video using multicast, rather than the default unicast method. A suitable
Multicast address is generated, but you can edit the result manually if you need to. To update the address
you can enter a new address and click
Apply . Please take time to consider the following information before
enabling this feature.