Newtec SAT2200, Руководство по установке

Страница: 32 / 47

Terminal Installation Satellite Terminal Installation Guide
version 2.0 - 32 -
3.3.3 Rough Pointing
3.3.3.1 Vertical Pointing
The correct elevation angle was already set during the installation of the antenna.
Verify that the elevation angle of the masthead still corresponds to the value you have found in the
antenna pointing information, and that it did not change during the assembly of the antenna (e.g. due
to the weight of the antenna dish).
Adjust if necessary (see section 2.4).
3.3.3.2 Horizontal Pointing
The correct azimuth angle was already set during the installation of the antenna.
Verify that the azimuth angle still corresponds to the value you have found in the antenna pointing
information, and that it did not change during the assembly of the antenna. Adjust if necessary
(see section 2.5).
Switch on the Point&Play tool by slowly turning the volume wheel until the green LED illuminates.
Put on the earphone and adjust the volume if necessary. Now the actual pointing procedure can start.
No Tone
Check if the battery of the Point&Play tool is not dead.
Since the correct elevation and azimuth angles have already been set, you should hear a high
uninterrupted tone (see section 3.3.2.1).
If this is not the case, adjust the elevation and/or azimuth angles until you hear the highest possible
continuous pitch tone (detection of the correct satellite). Make sure you position the antenna in the
middle of this highest tone range.