1.3.3 INSTALLATION PRECAUTIONS
• To prevent overheating the device, arrange it in a position allowing the flow of air through the slots in
the casing. Ensure at least 5 cm of free space when installing inside a rack. For the same reason, do not
install sources of heat, such as radiators or hot air ducts. Keep away from direct sunlight. Do not install
in areas subject to excessive dust, mechanical vibrations or shocks.
• Do not arrange this device on an unstable surface, such as a tottering or slanted table. The device
could fall causing injury or mechanical failures.
• Do not install the device in a place where it could be exposed to humidity or water. Do not direct a jet of
water onto the device: risk of fire, electrocution or mechanical failure.
• Stop using the device if water or other material should penetrate inside: risk of fire and electrocution.
Contact the retailer or authorized installer.
• Slots and openings in the cabinet are provided for ventilation.
These openings must not be blocked or covered.
• Do not place heavy or heat generating objects on top of the device: this could damage the casing and/
or increase internal temperature causing faults.
• Do not cover the device with a cloth while it is running to prevent deforming the external casing and
overheating the internal parts: risk of fire, electrocution and mechanical failure.
• Keep magnets and magnetized objects away from the device to prevent faults.
• Do not use the device in presence of smoke, vapor, humidity, dust or intense vibrations.
• Wait for a while before operating a device immediately after transporting it from a cold place to a
warm place and vice versa. Wait on average for three hours: this will allow the device to adapt to the
new ambient (temperature, humidity, etc.).
• The monitor is provided with a plastic base and rubber feet. It can be positioned on a horizontal
surface, such as a desk or a table. Make sure that the device is fastened firmly and that it is not resting
on unstable supports or surfaces. Dropping could cause severe injury and damage the device.
• Remember to adjust the brightness and contrast to obtain a perfect image.
• The monitor can also be installed on the wall by means of a bracket (not provided).
1.3.4 CLEANING THE DEVICE
• Rub delicately with a dry cloth to remove dust and dirt.
• Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
• Do not use volatile liquids (such a petrol, alcohol, solvents, etc.) or chemically treated clothes to clean
the device to prevent deformation, deterioration or scratches to the paint finish.
1.3.5 PRIVACY AND COPYRIGHT
• The LED monitor is a device for CCTV systems. Recording of images is subject to the laws in force in
your country. Recording of images protected by copyright is forbidden.
• Product users shall be responsible for checking and respecting all local rules and regulations
concerning monitoring and recording video signals. The manufacturing SHALL NOT BE LIABLE for use
of this product not in compliance with the laws in force.
2
