Model N-STP Operation Manual
4.2.2. Laser Power Supply Remote Connector
Mains voltage (115 VAC or 230 VAC) is present on remote connector terminals when power
supply key switch is in the “I” (on) position. The power supply must be switched to the “O” (off)
position and disconnected from mains power before removing the remote connector plug
from the socket.
The remote connector is provided as a safety feature to allow remote actuation of the laser
power supply. It must be connected to the power supply rear panel for the laser system to be
enabled. If remote actuation is desired, ensure that the cable and remote switch are rated for
the specified power supply input voltage and current. The remote switch will actuate the
power supply only when the main power switch is swit
ched on (“I”). As supplied, the polarized
remote connector plug is wired with an internal jumper. If the connector is to be used with a
remote external switch, modify the plug as follows:
1.
Switch off power and disconnect power supply from main power.
2.
Remove remote connector plug from socket on power supply rear panel by pulling straight
out.
3.
Press out silver-colored locking pin. Do not discard pin.
4.
Remove plug shell.
5.
Remove vinyl cap covering plug terminals.
6.
Remove shorting wire from plug terminals.
7.
Slide the plug shell onto remote connector cable.
8.
Solder cable leads to plug terminals.
9.
Slide the plug shell back on to plug.
10.
Install locking pin removed in step 3.
11.
Insert connector into socket on power supply rear panel.
If the laser system is not operated in accordance with these instructions, the function of
essential safety features will be impaired. The laser system has no user serviceable parts within
and requires no user maintenance.
9
IMPORTANT
