Newport ESP302, Руководство для стартапов

Страница: 18 / 46

ESP302 Controller Start-Up Manual
A1270B1 - EDH0411En1021 – 02/20 10
3.0 Getting Started
3.1 Unpacking and Handling
It is recommended that the ESP302 Controller/Driver be unpacked in your lab or work
site rather than at the receiving dock. Unpack the system carefully; several cables are
included with the equipment. Inspect the box carefully for loose parts before disposing
of the packaging. You are urged to save the packaging material in case you need to ship
your equipment.
3.2 Inspection for Damage
ESP302 Controller/Driver has been carefully packaged at the factory to minimize the
possibility of damage during shipping. Inspect the box for external signs of damage or
mishandling. Inspect the contents for damage. If there is visible damage to the
equipment upon receipt, inform the shipping company and Newport Corporation
immediately.
WARNING
Do not attempt to operate this equipment if there is evidence of
shipping damage or you suspect the unit is damaged. Damaged
equipment may present additional personnel hazard. Contact
Newport technical support for advice before attempting to plug in
and operate damaged equipment.
3.3 Packing List
Included with each ESP302 controller/driver are the following items:
•
Power cord.
• Straight-through Ethernet cable, black, 5 meters.
•
ESP302 Start-Up Manual.
If there are missing hardware or have questions about the hardware that were received,
please contact Newport.
3.4 System Setup
This section guides the user through the proper set-up of the motion control system. If
not already done, carefully unpack and visually inspect the controller and stages for any
damage. Place all components on a flat and clean surface.
WARNING
Before operating the ESP302 controller, please read chapter 1.0 very
carefully.
CAUTION
The ESP302 controller includes several protections against wiring
and configuration errors. However, attempting to operate with wrong
connections or parameters may lead to material damage.
CAUTION
No cables should be connected to the controller at this point!