(6)
IMPORTANT: Observe all governing codes and ordinances.
Tank
must be
mounted
vertically
Quick - connector fittings
connects to cold water
STEP 1 - Mount The Tank:
The dial must be in the OFF position during installation.
Position the tank vertically beneath water dispenser so that the flexible tube from the water dispenser reaches
the center tube on the tank in the shortest distance possible. Keep the tank at least .4” (10mm) away from the
wall. The back side of the tank can be mounted against the wall. To mount to dry wall, use two mounting
screws and plastic anchors.
NOTE: The tank must be positioned so that the hose to the water dispenser does not twist or kink.
STEP 2
–
Install the
Water Dispenser
Follow the water dispenser installation manual to install the dispenser to the sink.
STEP 3
-
Connect the Water Dispenser to the Tank
Connect the water dispenser to the tank (see
Figure 1
). Remove the red clips from the quick-connect fitting
(Fitting #1) supplied with the tank. Use this fitting to connect the 1/4” water dispenser outlet tube (red color
hose) to the rear water connection inlet at the top corner of the tank. Push the tube straight into the quick-connect
fitting as far as possible for both connections.
Reattach
the red clips onto the quick-connect fitting. Use the brass
fitting supplied with the water dispenser (Fitting #3) to connect the ¼” water dispenser inlet tube (clear color
hose) to the center connection outlet on the top of the tank.
NOTE: DO NOT twist or kink the tubes. Tubes may be cut to length if necessary
.
NOTE: DO NOT lengthen the tubes. Dispenser performance will be impaired and warranty will be void.
Debris Screen Filter
Quick‐connect fitting
(Fitting
#1)
connects
the the Red water inlet tube to the water
connection outlet on the rear of the unit
Red Hose
The Blue tube connects to the cold water supply
with the quick‐connect fitting with filter
(Fitting
#2).
Filter’s orientation should point in the
direction of water flow as shown below.
Red Hose
Sample Dual Handle Hot/Cold Water Dispenser
(Single Handle Hot Water Dispenser not
shown)
Water Flow Direction
Figure
1
Blue Hose
Connect the clear hose to the center
outlet tube on the top of the tank
Compression fitting
(Fitting
#3)
, supplied
with the water dispenser
