2011
Dutch Star Diesel Pusher
by Newmar
6:5
Touch Manual Control Pad
To extend, press the “ON” button on the HWH control panel. The “POWER ON” light will illuminate. Place pads
under the jacks, if necessary, at this
time. A lit yellow “LEVEL” light
indicates that the end, side, or
corner is low. Push an “EXTEND”
(up arrow) button to extend the
jack pairs according to the lit
yellow lights. Always level the
vehicle from side to side before
leveling the vehicle from front to
rear. Two yellow “LEVEL” lights
can be on at one time. Extend the
jack pair accordingly until all
yellow lights are out. If the ground
is too uneven, the jacks may not
have enough stroke to level the vehicle. The vehicle may have to be moved. After the vehicle is level, the jacks
not used for leveling may be extended until they touch the ground. This provides additional stability against wind
and activity in the vehicle. Do this, by pushing the front and/or rear “EXTEND” buttons as needed to extend any
remaining jacks. Do not use the right or left “EXTEND” button. Push the “OFF” button on the touch panel. Turn
the ignition switch off.
IMPORTANT
The leveling system should be cycled once a month or whenever the vehicle is used to keep the system in operating
condition.
To retract the jacks, turn the ignition switch “ON” but do NOT start the engine. Press the “ON” button on the
control panel one time. The “ON” indicator light will glow steady. Press the “STORE” button. As each jack
retracts, its red “WARNING” light will go out. The vehicle can be moved as soon as the red “WARNING” lights
are out, provided the jacks are in the STORE/TRAVEL position. The system will automatically shut down
approximately two minutes after the four individual red “WARNING” lights are out. Refer to the HWH Owner’
s
Manual for more instructions. The engine can be started once the jacks have fully retracted.
Electric Steps
This unit is equipped with electric double entrance door steps. If so, the switch to operate these steps may be
located in an overhead cabinet above the entrance door. When the power switch for the steps is in the on position,
simply open the door and the steps will open. Detailed operation for the electrical entrance door steps is as
follows:
1.
Turn the step power switch on.
2.
Close the door. The step should retract and lock into the up position.
3.
Open the door. The step should extend and lock into the down position.
4.
Turn the step power switch off. The step should remain in the extended position when the door is closed.
Turning off the power with the step retracted will hold the step in a retracted position as well.
Содержание Dutch Star 2011
