• Connect the device’s black wire to the HOT (black) wire in the wall box.
• Connect the device’s white wire to the NEUTRAL (white) wire in the wall box.
• Connect the device’s green wire to the GROUND (green or bare) wire in the
wall box (only if a grounding wire is available -- if not, attach the green wire
to the wall box using a grounding screw).
➂
Fold the wires into the electrical box. Screw the Power2U into the
electrical box. Screw the faceplate into the Power2U.
➃
Turn the power back ON at the circuit breaker or fuse panel. Test the
Power2U receptacle (125V) power outlets and the 5.2V USB outlets to verify
proper operation. The USB outlets are only powered when a USB cord is
plugged into the port. There is an internal switch that is depressed when the
USB connector is inserted and then turns the USB power on.
Installation & Use
The installation of the Newer Technology Power2U is straightforward and
the same as replacing a normal electrical receptacle. The Power2U is a large
device; make certain that your electrical box can legally accommodate it!
Power2U Installation Steps:
➀
Turn the power OFF. This is done at the electrical circuit breaker box
or the fuse box. Find the circuit or fuse that corresponds to the receptacle
where you will install the Power2U, then turn the circuit breaker OFF or
remove the fuse before proceeding!
➁
Connect the wires to the Power2U.
• Strip the wires inside of your wall box
1/2” (13mm) to accept the Power2U
device wires.
Wire
13mm
Strip wire 13mm (1/2”)
Patented by Winon Electrical Co. Ltd. # US 7,997,925
UL File # E339607
© 2015 Newer Technology, Inc.
R5 DM 5/1/2015
INSTALLATION VIDEO
www.newertech.com/p2u-install/
