053003
Brew Mode - One of three brew profiles may be requested by a simple press and release of any of the three
buttons. If the heater is on, the brewer will enter auto arm mode (basket & clock icon flashing). Otherwise, a brew
will start. Under coffee mode (see program mode) if the time programmed for the brew exceeds the minimum time
required, the excess time will be distributed throughout as “pauses” in the brew cycle. Each pause may come only
after 20 seconds of “on time”. Under tea mode, the machine will undergo a series of pauses during concentrate
and dilution delivery, depending on its program settings. A brew may be cancelled by pressing any button.
Auto Arm Mode - Under AUTO ARM mode, the machine will display the TOP sensor temperature reading until it
is ready to brew. Auto arm mode may be cancelled by pressing any button.
Temperature Monitor Mode - By holding down the center button while the LEFT button is pressed, the display will
show the temperature readout for the TOP thermistor in the tank. Pressing any button at this point will clear the
display. By holding down the center button while the RIGHT button is pressed, the display will show the
temperature readout for the BOTTOM thermistor in the tank. Again, pressing any button at this point will clear the
display.
Error Modes - To reset an error condition simply power the machine off and back on. If the error continues, check
the condition of all sensors, hardware & wiring.
ER1 – Top thermistor shorted
ER2 – Top thermistor open
ER3 – Bottom thermistor shorted
ER4 – Bottom thermistor open
ER5 – Heater has run for more than 20 minutes continuously
Newco Enterprises, Inc. * 1735 South River Rd. * P.O. Box 852 * St. Charles, MO 63302