Proprietary to NeWave® Sensor Solutions 1.0
13
Multi Use Portal Application
Materials Supplied:
• (1) SLS smart PORTAL – A and B-Panel
• (2) Safety Yellow Angle Iron
• (12) 3/8” x 3” Concrete Anchor Screws
• (8) 1/2” x 4” Concrete Anchor Screws
Materials Needed:
• Tape Measure
• Concrete Impact Driver
• Concrete Rotary Hammer Drill
• 5/16” SDS Drill Bit (minimum 6” long)
• 7/16” SDS Drill Bit (minimum 6” long)
• 9/16” Impact Socket
• 3/4” Impact Socket
Steps:
1. Place the two angle-iron on opposite sides of the dock door centered at approximately 3-4
feet in from the wall and 4-8 inches outside of the dock door track. (The dimensions will
vary based on the dock door environment).
2. Once the angle-iron have been placed, drill holes into the concrete using the 5/16” SDS
Drill Bit.
3. Using the 9/16” Impact Socket, screw the 3/8” x 3” Concrete Anchor Screws into the
holes, securing the angle iron.
4. Next, place the A-Panel on the right side of the dock and the B-Panel on the left side of the
dock, butting the graphics-side of the panels up to the angle-iron. Center the panels on
the angle-iron.
5. Again, using the 5/16” SDS Drill Bit, drill four holes per panel in the designated spots on
the feet of the panels.
6. Secure the panels by screwing in the 3/8” x 3” Concrete Anchor Screws into the holes.
7. Next, place two bollards (sold separately) on either side of the dock approximately 4-6
inches out from the edge of the angle-iron and flush with the front face of the angle-iron.
8. Using the 7/16” SDS Drill Bit, drill holes into the concrete at the specified areas at the
feet on the bollards.
9. Secure the bollards by screwing in the 1/2" x 4” Concrete Anchor Screws using the 3/4"
Impact Socket.
10. Once all hardware is secured in the ground, open the top access panel on the B-Panel.
Inside there will be two 25’ cables. Unscrew those cables from the bracket inside and
feed the end that was just unscrewed, through the hole on the told of the panel and
reattach to the bracket.
