7
A Name You Can Trust
The unit must be placed within reach of a properly-rated grounded socket.
Never place any obstacles around the air inlet or outlet of the unit.
Allow a minimum 6-inch clearance on all sides for efficient operation.
INITIAL SETUP
IMPORTANT: Do not plug in the unit before installing a
water bottle. Operating the unit with an empty hot water
tank can cause physical damage to the water dispenser.
WATER BOTTLE INSTALLATION
This unit is designed to work with 2-gallon, 3-gallon or 5-gallon bottles of
drinking water. To install the water bottle:
1.
Remove the label from the cap of the bottle.
2.
Use a clean cloth to wipe the cap and neck of the bottle.
3.
Lift and invert the bottle, and insert the bottle neck into the water guard.
4.
Allow bottle to fill the internal tank and wait for bubbles to stop rising from
the bottom of the bottle.
5.
Turn on the Red (hot) tap until water flows from it.
6.
Plug the unit into an appropriate wall outlet.
7.
Turn on the switches on the rear of the unit one at a time (do not turn on
the switches at the same time). The heating lamp and the cooling lamp will
light up.
INITIAL CLEANING
This unit has been cleaned and sanitized prior to shipping. However, to remove
dust accumulated during shipping, we recommend rinsing the water lines and
tank upon initial operation:
1.
Allow the unit to run with the water bottle in place for 30 minutes.
2.
After 30 minutes, turn the unit off, unplug it, and remove the water bottle.
3.
Run all taps until they are empty, then open the drain plug on the back of
the unit and drain remaining water from the dispenser into a bucket or
other container.
4.
Once the unit has been completely flushed, you can replace the bottle and
restart the unit according to the instructions above.
