5
newair.com
sure the power line of the unit is disconnected.
•
Do not connect or disconnect the electric plug when your hands are wet.
•
Unplug the appliance or disconnect power before cleaning or servicing.
Failure to do so can result in electrical shock or death.
•
Do not attempt to repair or replace any part of your appliance unless
it is specifically recommended in this manual. All other servicing
should be referred to a qualified technician.
•
This appliance is CFC- and HFC-free and contains small quantities of
Isobutane (R600a) which is environmentally friendly, but flammable. It does
not damage the ozone layer, nor does it increase the greenhouse effect.
Care must be taken during transportation and setting up of the appliance
that no parts of the cooling system are damaged. Leaking coolant can ignite
and may damage the eyes.
•
In the event of any damage:
- Avoid open flames and anything that creates a spark,
- Disconnect from the electrical power line,
- Air the room in which the appliance is located for several minutes, and
- Contact the Service Department for advice.
•
The more coolant there is in an appliance, the larger the room it should be
installed in. In the event of a leakage, if the appliance is in a small room,
there is the danger of combustible gases building up. For every ounce of
coolant, at least 325 cubic feet of room space is required. The amount of
coolant in the appliance is stated on the data plate on the back of the
appliance. It is hazardous for anyone other than an authorized Service
Person to carry out servicing or repairs to this appliance.
•
Take serious care when handling, moving, and using the appliance to avoid
either damaging the refrigerant tubing or increasing the risk of a leak.
•
Replacing component parts and servicing shall be done by factory authorized
service personnel so as to minimize the risk of possible ignition due to
incorrect parts or improper service.
FOLLOW WARNING CALL OUTS BELOW ONLY WHEN
APPLICABLE TO YOUR MODEL
•
Use two or more people to move and install appliance. Failure to do so can
result in back or other injury.
•
To ensure proper ventilation for your appliance, the front of the unit must
be completely unobstructed. Choose a well-ventilated area with
temperatures above 50°F (10°C) and below 100°F (38°C). (Optimum
operation occurs within the range 72° to 78°F, or 23°-26°C.). This unit must
be installed in an area protected from the elements, such as wind, rain,
water spray or drips.