11
Bolt the Center Support into the holes found
in the middle of the 6’ or 8’ assembly. Use two
1/4” x 3/4” bolts and 1/4” lock nuts with four
1/4” washers per side.
17
Place the cross supports into the slots on
the top of the long cross beam assemblies.
18
Note:
If installing 6’ VersaRac you will
have two cross supports left over.
Place both wire grids with notched corners on
the ends of the VersaRac. Notched corners should
provide clearance for the Vertical Angle Supports.
19
Place one wire grid between the previously
installed grids if installing a 6’ VersaRac, or 2
if it is an 8’ VersaRac.
20
Note:
If installing 6’ VersaRac you will have one grid section left over.
Warning:
Periodically (at least quarterly) inspect your VersaRac unit to ensure beams are seated properly and
brackets are firmly connected to the overhead supports. If there is no sufficient structure, remove
the overhead and install the ceiling mounting angles into proper ceiling support.
