SECTION 10 -- ENGINE -- CHAPTER 1
10-38
13. Hitch the front suspension, 1, to a hoist. Remove
the suspension retaining pin, 2, on the support,
3, and remove the front suspension.
14. Hitch the front suspension support, 3, to a hoist,
remove the sump retaining bolts and remove the
support.
15
Installation
To install the engine, proceed as follows:
CAUTION
Always use appropriate tools to align fixing
holes. NEVER USE YOUR FINGERS OR HANDS.
16
1. Apply the torque settings listed in the torque
table.
2. Hitch the front suspension support to a hoist and
install to the sump, securing in position with the
retaining bolts.
3. Hitch the front suspension to a hoist. Install on
the support and assemble the suspension
retaining pin.
4. Install the front ballast and tow bar.
5. Install the oil vapor recovery piping and the
turbocharger feed piping (where removed).
6. Install the piping on the upper part of the tank.
7. Install the piping and sleeve located on the lower
part of the tank.
8. Install the upper tank support and tighten the
retaining bolts.
9. Install the radiator upper piping sleeve.
10. Install the radiator lower piping sleeve.
11. Fill up with coolant.
12. Install the engine side guards and retaining bolts.
13. Assemble the roll bar support and retaining bolts.
14. Install the rubber heat guard on the support.
15. Carry out the relative clutch assembly
operations.
16. Bleed the fuel system of air as described in this
section.