New Holland flexicoil 5000 AD.A, Руководство по обслуживанию

Страница: 11 / 31

SECTION 1 - GENERAL INFORMATION
page 1-3
Hydraulic Fitting Identification
GENERAL SERVICE INFORMATION
NOTE: Read instructions carefully before you begin.
1. Be sure to read and follow all instructions to ensure
proper assembly, operation, and service of the
implement.
2. Service may require the use of a forklift or other
suitable lifting device.
3. Implement must be serviced on a flat surface.
4. Left and right directions are determined from the rear
of the implement facing the forward direction of travel.
5. Use a suitable sealant on hydraulic connections;
sealant paste is recommended. Be careful to prevent
sealant from entering the hydraulic system.
6. Apply a thread sealant to all female-to-male pipe
thread connections.
7. Do not allow tape to enter the hydraulic system.
8. Do not use a thread sealant on ORB or swivel fitting
connections.
NOTE: If you are assembling or servicing the
implement inside of a building, ensure the door
opening is large enough to allow the
implement to be removed after assembly.
Check the Specifications Tables in this section
for the overall height and width in transport
position.
NOTE: Additional bolt torque information can be
found later in this section.
NOTE: Pipe thread fittings (1), O-ring boss fittings (2) and JIC fittings (3) may be the types of hydraulic fittings used.