STEP T WO
3
Layout the two beams parallel to one another. Measure 1 1/2” and
3” in from each end of both beams and put a mark. Place two of the
rafters onto each end of the beams and position them between the
marks. This creates a basic “frame” of the top assembly.
Making sure the frame is square, fasten the rafters to the beams as
illustrated using one 3” screw for each end.
Note: do not over tighten the screws when fastening the beams or
rafters. This may cause the vinyl to crack. Screws are self-tapping and
require no pre-drilling.
Place the remaining rafters onto the beams, making sure they are
evenly spaced. The distance between the rafters should be ± 13 3/8”.
Fasten each on in place shown in the previous step.
Position the top of each panel between the beams and against the
outside rafters of the top assembly as shown. Keep the top of the
posts flush with the top edge of the beam (Note: for added head
clearance, shift the beam up). Using two 3” screws, secure the beam
to the posts as illustrated.
Using two 3” screws, fasten the end filter onto the posts as shown.
1
Richmond Grande Arbor
Connect Beams to Side Panels
2
www.newenglandarbors.com
3
4
1
2
3
5
4
5
