6
4
5
Once the ground stop (see sketch
3 below) is at ground level, the
mount is completely installed.
Slide the plastic sleeve over the
steel mount until the bottom rests
on the ground stop.
Line up the holes in the plastic
sleeve and steel mount. Take a
locking plug, or alternative bolt
and wing nut (included) and
insert it into the hole until it is
firmly in place. Repeat steps 2
to 5 for the remaining mounts.
Once you have installed and
verified the orientation of each
mount, set your arbor posts onto
the mounts and push down to
ground level. Using one of the
screws provided, secure the
bottom of each post to the
mounts as shown.
If you have questions concerning the installation of this product and require assistance, please call our
Customer service department at 1-800-282-9346 (ext.#20)
, weekdays from 8:00 am. to 4:00 pm. EST.
If you have comments or suggestions about this product, let us know! Call:
1-800-282-9346 (ext.#24)
.
Thank you for purchasing the “Arbor Mounting System”.
2VFTUJPOT
1. For installation of the surface mounts on concrete, use the bit provided to drill your pilot holes.
Fasten each mount in place using the tapcon screws provided.
2. For installation of the surface mounts on wood or a similar surface, use wood screws (not included).
3. Basic identification sketch of each part:
"EEJUJPOBM*OGPSNBUJPO
Plastic Sleeve
(3 1/2” , 4” or 5”)
Steel Surface
Mount
Steel Ground
Auger
Locking
Plug
Steel Turning Rod
Ground Stop
1
2
3
4
6
5
Bolt &
Wing Nut
