New Buck Corporation Buck Stove FP-327-ZC, Инструкция по эксплуатации

Страница: 37 / 45

WARNING
IF YOU SMELL GAS:
* SHUT OFF GAS SUPPLY
* DO NOT TRY TO LIGHT APPLIANCE
* DO NOT TOUCH ANY ELECTRICAL SWITCH; DO NOT USE ANY
PHONE IN YOUR BUILDING
* IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOR’S
PHONE. FOLLOW THE GAS SUPPLIER’S INSTRUCTIONS.
* IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE FIRE
DEPARTMENT.
IMPORTANT:
Operating heater where impurities in the air exist may create odors. Cleaning
supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc. create
fumes. These fumes may mix with combustion air and create odor.
OBSERVED
PROBLEM
H e a t e r p r o d u c e s a
clinking/ticking noise just
after burner is lit or shut
off
Heater produces unwanted
odors
Heater shuts off in use
(ODS operates)
Gas odor even when
control knob is in “OFF”
position
Gas odor during com-
bustion
POSSIBLE
CAUSE
1. Metal expands while heating
or contracts while cooling.
1. Heater burning vapors from
paint, hairspray, glues, etc.
(See
Important above)
2. Low fuel supply
3. Gas leak (See
WARNING
above)
1. Not enough fresh air is
available
2. Low line pressure
3. ODS/Pilot is partially clogged
1. Gas leak (See
WARNING ,
above).
2. Control valve defect
1. Foreign matter between
control valve and burner
2. Gas leak (See WARNING
above)
SOLUTION
1. This is common with most
heaters. If noise is excessive,
contact a qualified service
person.
1. Ventilate room. Stop using odor
causing products while heater is
running.
2. Refill supply tank
3. Locate and control all leaks. See
Checking Gas Connections.
1 . Open window/door for
ventilation
2. Contact local propane company
3. Clean ODS/Pilot
1. Locate and correct all leaks (see
Checking Gas Connections)
2. Replace control valve
1. Remove foreign matter from gas
tubing
2. Locate and correct all leaks (see
Checking Gas Connections)
Page 35