NEW BRUNSWICK SCIENTIFIC innOva 4200, Руководство по эксплуатации

Страница: 32 / 73

32
New Brunswick Scientific User’s Guide
WARNING!
The following sections are ONLY for qualified Electrical & Service
Engineers, who will always disconnect the power cord before performing
any service on the shaker.
7.12 Using Ancillary Equipment with the Innova 4200
The Innova 4200 has a special internal AC socket that is used to power ancillary
equipment such as magnetic stirrers, rockers, rollers and small shakers.
In most cases, the equipment used will be light duty rockers or rollers. However, if
heavier equipment is desired, the operator should verify that the stainless steel shelves
supplied can support the load.
In addition, be sure to verify that the equipment operating inside the Innova 4200 does
not affect the stability of the unit. This is accomplished by operating the particular piece
of equipment under the expected load and speed conditions. If the Innova 4200 vibrates,
limit the load and/or speed conditions for the operation of the ancillary equipment.
If the Innova 4200 is intended to be used as a shaker at the same time, both shaker and
ancillary equipment should be run under expected load and speed conditions. If the unit
vibrates, the shaker speed and/or the load should be reduced, or the Innova 4200 should
not be used as a shaker at the same time the ancillary device is in operation.
#
NOTE:
It has been found that an Innova 2050 orbital shaker weighing 35 lb.
(15.9 kg) could be operated inside the Innova 4200 at 250 rpm while the
Innova 4200 is shaking at 250 rpm.
The outlet is located inside the shaker chamber on the upper right side
. It is important
to note that this AC supply is the same as the main supply of your 4200. If your unit
operates off a 115 volt supply, then any ancillary equipment you plug into the internal
socket must also operate at 115 volts.