Radio
1.
Press
ON / STAND BY
to switch on the radio.
2
.
Press
BAND
once or more to select F
M
or
AM
waveband.
3
. The display shows the radio station details throughout the radio mode.
4.
Select your station by using
or
TUNING
–
5.
Adjust the sound with
VOLUME
.
6.
To switch off the radio, press
ON / STAND By
once.
Tuning
Manual tuning
Press
or
TUNING
–
briefly, once or more until the right frequency is
found.
Automatic tuning
1.
Press and hold down
or
TUNING
–
until the display frequency starts
to run.
2.
When a station of sufficient strength has been found tuning stops, or you can
stop automatic tuning by pressing
or
TUNING
–
again.
Presets
You can store the frequencies of up to 50 radio stations in the memory, (30 in FM
wave bands; 20 on AM wave band). A stored frequency can be erased from the
memory by storing another frequency in its place.
1.
Press PROGRAM once to enter programming mode.
2.
Select your wave band and tune to your desired station (See
TUNING
).
3.
Press PROGRAM once again to confirm the selected station.
4.
Press or PRESET
– to select the desired memory location.
5
To listen to a preset station:
• select your waveband;
• press the or PRESET – for selecting your desired station.
To improve reception:
- For FM, pull out the telescopic aerial. To improve FM Reception incline and turn
the aerial, reduce its length if the FM-signal is too strong (very close to a
transmitter).
- For AM, the set is provided with a built-in aerial, so there is no need to use the
telescopic aerial.
Turn the set to find the best position.
Volume
Adjust the sound with the controls or VOLUME -
You may connect headphones with 3.5mm, plug to socket PHONES. The
loudspeaker is then muted.
-Page 3
