Neve GENESYS BLACK, Руководство пользователя

Страница: 174 / 237

Apple Logic Pro
Before using the Genesys with an Apple Logic Pro system, please ensure
that both systems are properly configured as outlined on page Error:
Reference source not found.
This involves:
•
Setting the IP addresses on Genesys and the DAW computer.
•
Connecting the network ethernet cabling.
•
Installing the ipMIDI driver.
Genesys Setup
u
Go to Settings / Services and make sure Apple Logic Pro is
selected at the top of the screen.
u
For #1 , select the MIDI Port, then the console 8 block of faders on
which you wish these DAW tracks to appear.
NB:
The 8T faders are referred to in the pull-down list of options as Master .
u
Repeat for all the other available MIDI Ports and fader blocks on the
console.
NB:
This mapping must match that set in Logic Pro. The same MIDI Port
cannot be used more than once (including the one set for Midi Timecode).
The 8 block of faders can only be linked to a single MIDI Port and not
repeated.
The DAW control is limited to controlling a maximum of 48 Logic tracks or
6 MIDI Ports (this does not include the MIDI Port used for MTC).
u
Once set, click OK. Follow the on-screen instructions to re-launch the
software to apply the new changes.
Apple Logic Pro Setup
u
On the Logic DAW, from the menu bar at the top of the screen click
Logic Pro / Preferences / Control Surfaces / Setup .
u
At the top of the screen, select New / Install .
You will be presented with a list of possible DAW Master Controllers.
u
S
elect the Mackie Designs – Mackie Control – Logic Control entry
and click Add .
u
Once added, click on the Mackie Control icon, and at the top of the left
hand pane, set the Input and Out Port port to Port 1 (or whatever was
set in the Genesys software for the first block of 8 tracks).
The Input / Out Port port parameters for the DAW Master Controller and
each DAW Extender Controller must match port-for-port with that set in
the Genesys software.
u
On the Logic DAW, from the menu bar at the top of the screen again
click Logic Pro / Preferences / Control Surfaces / Setup .
u
At the top of the screen, select New / Install .
- 174 -