Nevadent NAZ 2.4 C3, Руководство по эксплуатации, Страница: 23 / 102

■ 20 │
GB
│
IE
NAZ 2.4 C3
3) Open the lid
0
of the brush holders
q
and place the replacement brush
heads in the four slots provided . Close the lid
0
again .
4) Place the handset on the charger
8
so that it slides onto the pin on the
base .
5) Allow the handset to charge up for around 14–16 hours before using it for
the first time . The charging light
7
on the front of the handset lights up red
during the charging process .
6) Use the handset repeatedly without charging the battery until the perfor-
mance becomes noticeably weaker or the toothbrush stops working and
the charge indicator
7
flashes red . Then recharge the battery for 14–16
hours . When the appliance is fully charged, the charge indicator
7
lights up
green .
7) Charge and discharge the toothbrush completely 3 times . The battery will
have then reached its full capacity .
8) You can now leave the handset in the charger
8
after every use, so as to
always have full power available .
Fitting/removing brush heads
■ To remove the brush head
1
, pull it upwards and off the drive shaft
2
.
■ When fitting the brush head
1
, ensure that the drive shaft
2
on the handset
slides precisely into the socket on the brush head
1
.
Push the brush head
1
down until it completely covers the drive shaft
2
.
NOTE
You can order replacement brush heads from our Service department
(see section "Ordering replacement parts") .
You can also use the brush heads for the models NAZ 3 .7 A1 and
DAZD 3 .7 LI B2 (also available from Lidl) .
The toothbrush is also compatible with brush heads from the following
Oral B
©
* models:
Oral-B Ortho, Oral-B Precision Clean, Oral-B 3D White, Oral-B Cross
Action, Oral-B Stages Power, Oral-B Sensitive, Oral-B Deep Cleaning .
*Oral-B is a registered trademark of Procter & Gamble .