Neuton Garden Cart, Руководство по безопасности и эксплуатации

Страница: 16 / 44

Assembling Your Cart
Before using your Cart, you must first fully assemble it by performing these main tasks:
1. Read these
Safety & Opera ing Ins ruc ions
fully.
t t t
2. Attach the buckets.
3. Attach the drive train.
4. Attach the wheels.
5. Attach the upper handle.
6. Attach the controls caddy.
7. Plug in the wire harness.
8. Secure the wire harness
Each of these steps is described in detail below.
Tools needed:
•
Phillips screwdriver
•
7/16" open-end wrench
•
Adjustable wrench
•
Safety scissors
1
.
Read the Safety Instructions
For your own safety and understanding, please read these
Safety & Operating Instructions
in their
entirety— paying special attention to Chapter 2: Important Safety Considerations — before assembling
and using your Cart. Your experience using your Cart will be greatly enhanced as a result of reading this
guide.
Upper bucket
Lower handles
Lower bucket
2. Attach the Buckets
•
Place the Upper Bucket upside down on a large,
clean, flat surface (such as a strong table or a
clean floor).
•
Place the Lower Bucket (again, upside down) on
top of the Upper Bucket, aligning it with the
channel rim. Make sure the two buckets are
connected the right way — the lower handles
must be aligned over the round handle holes in
the rear of the upper bucket.
•
Snap the two buckets together. Check to make
sure the two buckets are seated tightly together.
Tip: Look into each of the six screw holes in the
Lower Bucket; make sure they all align with
the inserts in the Upper Bucket and the two
buckets are firmly seated together. Then you
can easily screw in the screws.
Figure 1. Aligning and attaching the Upper and Lower Buckets.
12 NEUTON
®
GARDEN CART
Safety & Operating Instructions