Neurotech avivastim xp, Инструкция по эксплуатации

Страница: 27 / 32

Note 2: For this program, the output signal sequence is as follows:
Channel 1 enters a contraction cycle for 5 seconds and Channel 2 is off;
Both channels are off for a relaxation cycle of 5 seconds;
Channel 1 is off and Channel 2 enters a contraction cycle for 5 seconds;
Both channels are off for a relaxation cycle of 5 seconds.
Note 3: For this program, when the amplitude is at maximum, the value written to the R2R resistor network is
less than half the maximum of 255.
The Trigger mode ( ) is possible in Programs 1 – 5, 8 and 9. When the button is pressed the trigger mode is
activated and the unit enters a contraction cycle for as long as the key is pressed. When the key is released the
unit enters the relaxation cycle. To return to the programmed contraction/ relaxation cycle, press any of the
intensity keys. The stimulation builds over a 2 second period to the previously set intensity level.
WARNING: The selection and setting of the program should only be made by the treating clinician.
WARRANTY
Should your unit develop a fault within two years of purchase, neurotech
®
will undertake to replace or repair
the unit and parts found to be defective with no charge for labor or materials, provided the unit:
• has been used for its intended purpose and in the manner described in this instruction manual.
• has not been connected to an unsuitable power source.
• has not been subjected to misuse or neglect.
• has not been modified or repaired by anyone other than an approved neurotech agent.
This warranty complements existing national guarantee obligations and does not affect your statutory rights
as a consumer.
Service and maintenance
For service or repair please send your electrical stimulation unit to:
neurotech
PO Box 5179
Hoboken, NJ 07030
22
P
R
O
G
R
A
M
I
N
F
O
R
M
A
T
IO
N
&
W
A
R
R
A
N
T
Y