neuroConn DC-Stimulator, Руководство пользователя

Страница: 24 / 85

Chapter 3 - Getting Started
24
use of the device. To charge, connect the external charger to it (see Manual: External
charger for details).
With fully charged batteries, the DC-
STIMULATOR runs continuously for approx. 4-8 hours
depending on the equipment. Daily charging is recommended if the DC- STIMULATOR is
used regularly.
Charging of the completely discharged DC-
STIMULATOR batteries will take approx.
8 hours. It is therefore recommended that the batteries are completely discharged only when
there is time enough for charging.
For safety reasons, charging the batteries is possible only when no electrodes
are connected. The front plate of the DC-
STIMULATOR can be moved so that
either the electrodes or the external charger may be connected. Never try to plug
in both at the same time.
Only use the supplied processor controlled charger “Mascot 2116” for charging the DC-
STIMULATOR . It is optimized for the used type of battery and continuously monitors battery
state to prevent overcharging or overdischarging.
Use of other battery chargers, power supplies or energy sources for charging or
discharging can cause fire or explosion and can damage the DC-
STIMULATOR .
The manufacturer assumes no responsibility for any damage caused by such a
practice.
NiMH batteries will discharge slowly when not used for a longer period of time.
After 1 month of disuse approx. 30 % of accumulated energy will be lost. It is
therefore recommended system is recharged after a long period of disuse.
When the batteries reach the end of their life, please contact the dealer or
manufacturer. The DC-
STIMULATOR must not be opened to change the
batteries. The manufacturer accepts no responsibility for any injury caused by
this.
For environmental reasons, do not throw away the DC- STIMULATOR because
of the batteries it contains. Please return it to the manufacturer.