I M M E R S E
r e v e r b e r a t o r
U
S E R
G
U I D E
Thank you for purchasing our product. We really mean it. We hope to earn
your trust by delivering a quality product that inspires you to make great
music.
Neunaber products are designed and manufactured in Orange, California
USA. Please visit neunaber.net for more information and support.
Connections
We recommend that this pedal be placed at the end of your chain, after all
other effects. If you are using the overdrive channel of your amplifier, this
effect should be placed in the effects loop for best results.
The
P
OWER
J
ACK
accepts a standard (5.5 mm OD x 2.1 mm ID) center-
negative pedal power adapter (not included). The power adapter must be
between 9V and 12V and capable of supplying 70mA or more.
The
I
NPUT
J
ACKS
(right side) accept inputs directly from your instrument,
amplifier effects loop output, or other effect pedals via standard 1/4" (6.35
mm) phone connectors.
Input 1 only
accepts a mono input.
Both Inputs 1 & 2
accept a stereo input.
Input 2 only
accepts a stereo TRS input.
The
O
UTPUT
J
ACKS
(left side) supply output to another effect pedal, an
amplifier, or effects loop return via standard 1/4" (6.35 mm) phone
connectors. The buffered output is capable of driving long cables. If plugging
into the input of an amp, you should use the low impedance (Lo-Z) input if
available.
Output 1 only
supplies a summed mono output.
Both Outputs 1 & 2
supply a stereo output. Using both outputs creates a
stereo signal from a mono input.
Output 2 only
supplies a stereo TRS output.
The input and output connections are independent. You may—for example—
use a mono input with stereo outputs or stereo inputs with a stereo TRS
output.
Important Note:
input/output 1 and input/output 2 should not be used with
two discrete signals (such as two different instruments).
The
F
OOT
S
WITCH
bypasses the effect. The LED lights when the effect is
active. Bypassing the effect does not lower power consumption, because it
does not turn off power to the pedal.
The Immerse Reverberator implements a high-quality buffered bypass. The
signal is always buffered whether on or bypassed. We chose this type of
bypass because the last output in a pedal chain should be buffered, and
reverb is typically placed at the end of a pedal chain.
The
K
ILL
D
RY
switch removes the dry signal, leaving only the "wet" (effect)
signal. This is useful for parallel effect loops.
The
T
RAILS
switch changes the bypass mode between normal and trails.
Trails allows the effect to naturally trail off after the pedal is bypassed. With
normal bypassing, the effect is abruptly cut off; however, normal bypassing
results in lower noise while the pedal is bypassed.
Effects
Reverberation ("reverb") gives your instrument a sense of acoustic
spaciousness. There have been various methods of simulating this effect
over the years, several of which have evolved into their own distinct sound.
W
ET
™
is an updated version of Neunaber's renowned algorithm, with shorter
pre-delay, higher initial density and more balanced imaging.
fx level
adjusts the reverb level
depth
adjusts the length of the reverb tail (size of the acoustic space)
tone
controls the tone of the reverb only
modulate
controls the speed and depth of modulation in the reverb
