Postfach 4063
Ust.-Id-Nr.:
Märkische Bank eG
170 143 100 (BLZ 450 600 09)
Amtsgericht Iserlohn HRA 822
58663 Hemer
DE 812 45 68 50
Sparkasse Hemer
31 898 (BLZ 445 512 10)
pers. haft. Gesellschafterin:
Telefon 0049-2372-9274-0
e-mail:
Dresdner Bank AG
704 282 600 (BLZ 445 800 70)
Wolfgang Hellwinkel Verwaltungs GmbH
Telefax 0049-2372-3304
Postbank Dortmund 28 37
– 469 (BLZ 440 100 46) Amtsgericht Iserlohn HRB 2088
Geschäftsführer: Wolfgang Hellwinkel
IMPORTANT:
remove the waffle only with a wooden stick
clean the unit only with the attached brush or a similar one
NEVER
use abrasive detergents or sharp things
There is no guarantee on the coating!
Operating knobs/Temperature setting:
The desired temperature of the baking plates is set by the
regulators. By turning the knob the pilot light will go on which
means that the unit is switched on.
Remember:
the pilot light goes on
- the unit is being heated
the pilot light goes off
- the selected heat has been reached
Safety at work
Always make sure not to touch the hot units with bare fingers or hands. For hygienic
and safety reasons we recommend you to use wrist covering gloves. NEVER touch
the hot food with bare hands. Danger of burnings!
Danger of burnings and injuries:
Even if the upper plate has been opened until the stop, we advise you to use always
one hand for handling with a fork, spatula, etc. while the other hand is holding the
handle of the upper plate. Otherwise, by inattentiveness, the upper plate may happen
to fall down.
Cleaning
Disconnect unit from power supply and wait until the unit has cooled down before you
begin with any maintenance or cleaning procedures.
Food residues or spots on the surfaces have to be cleaned immediately (make sure
not to burn yourself as the units could still be hot) or at the latest before operation.
Use a dry cloth for cleaning if only slight residues have to be removed. If this is not
sufficient, please wait until all parts of the unit have become cold, and clean with an
appropriate, non-abrasive detergent.
The installation (only at not plug-in units) and any maintenance may only be done by
authorized technicians.
Never clean the units by a water-jet!
