NEULOG ELECTROCARDIOGRAM LOGGER SENSOR GUIDE
Off-line experiments
(Off-line experiments are for when you do not have a sensor connected
directly to a computer, tablet, smartphone, or NeuLog viewer).\
Materials needed:
NUL-218 ECG Sensor
3 Neulog Reusable Clamp Leads
BAT-200 Battery
Materials needed to configure your offline experiment:
USB-200 Module or WIFI-201 module or VIEW-101 Module
USB to mini USB cable (included with the USB-200 module).
Procedure:
1.
Connect the ECG sensor directly to the left side of a charged BAT-200
module.
2.
When ready to collect data press the “Start/Stop” button on the ECG
sensor, a red light will turn on for the duration of the experiment.
3.
To change the experiment settings first connect to your chosen device
(PC, Mac, tablet, smart device) and select the “Module setup” button.
(For more information on how to change the experiment settings view
quick start procedure section for your chosen device in this document.)
4.
After the experiment has concluded (when the “Start/Stop” button is
pressed again or the data collection period ends) connect the sensor to
your chosen device. (full instructions in each device’s quick start
procedure section)
5.
Open NeuLog software.
6.
Click the “Off-line experiment” button.
7.
Click the “Load data from sensors” button.
8.
Select which experimental data to upload. (5 experimental runs can be
stored at one time on the NUL-218 ECG sensor)
Restoring sensor’s factory default settings:
Procedure:
1.
Connect the USB-200 to a PC, Mac, tablet, or smart device.
2.
Connect the ECG sensor to a USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
3.
Open the NeuLog software.
4.
Click the “Tools” icon.
5.
Click the “Restore sensor’s factory defaults” on the menu.
6.
If prompted to clear the graph, click either the “Off-line either” or
“On-line experiment” (whichever you are using).
7.
Click “Clear experiment results”.
8.
Resume from step 4.