NEULOG PRESSURE SENSOR GUIDE
3.
Connect the pressure sensor to the USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
4.
Open the NeuLog software.
5.
Once a pressure sensor logo appears on the left side of the screen, the
probe has been automatically identified and you can begin
experimentation.
6.
If the pressure sensor is not automatically identified then click the
“Search for sensors” icon to find the sensor.
7.
Click the “On-line experiment” button; this will open a graph below.
8.
Click on the “Module setup” button located on the pressure sensor icon
in the module window to change the sensor settings if need be.
9.
Click on the "experiment set up" button to change the experiment
settings if need be (experiment duration for example).
10.
The pressure sensor will give a live reading in the box to the left of the
screen while plugged in.
11.
To run an experiment and collect data click “Run experiment”.
12.
To end data collection early, click “Stop experiment”.
Tablet, smart phone device
Materials needed:
NUL-210 Pressure Sensor
WIFI-201 WiFi module
BAT-200 Battery
Your pressure sensor needs to be connected to a WIFI-201 module. The
WIFI-201 module will create a closed NeuLog WiFi network which will
stream the NeuLog data to a device of your choosing. Once your device is
wirelessly connected to the NeuLog network you can run experiments and
collect data through a browser of your choosing.
Procedure:
1.
Connect the pressure sensor directly to the left side of a WIFI-201
module (no wires required).
2.
Connect a BAT-200 module to the right side of the WIFI-201 module.
3.
Although not required, we recommend plugging the BAT-200 to an
outlet using a USB to mini USB charger (such as a typical cell phone
charger). The WIFI-201 module will run for 15-75 minutes (depending
on the sensor) without being plugged in.
4.
The WIFI-201 can be powered directly using a mini to USB cord and
plugging it into your computer or a wall charger. Please note this
function is only available on WIFI-201 units with the USB icon on the
cover.
5.
For further WIFI-201 instructions or the WIFI-201 quick start guide
please visit:
www.neulog.com/Download/SoftwareandApplication.aspx
6.
The WIFI-201 indicator lights will flash; take no action until the LED
to the far left turns blue; this can take up to one minute.
7.
Take your tablet or smart phone, go to the WiFi settings and select the
Neulog network which matches the WIFI-201 Module ID found on the
back of the WIFI-201 device. (NeuLogXXXX for example).
8.
Give your device about 20 seconds to connect to the WIFI-201.
9.
Once the device is connected, go to your browser and type the website
wifi201.com into the URL bar, then wait for 30-60 seconds.
10.
You will see a “Control mode” icon in the browser, click on this icon.
11.
The browser will then load a new screen and begin to auto detect the
sensor(s); this can take a minute. (You can stop the search when the
sensor is found.)
12.
If the browser does not auto detect the sensor(s), select “Search for
sensors”.
13.
Once the sensor is found you will see an icon on the left side of the
screen for the temperature sensor. The icon will display real time data.