Neue NHK64C, Инструкция по эксплуатации

Страница: 7 / 15

7

IMPORTANT: You must observe the ventilation
requirements shown in the drawing opposite.

IMPORTANT: There are ventilation holes around the
outside of the hob. YOU MUST ensure that these
holes are not blocked by the work top, when you put
the hob into position (see drawing opposite).

IMPORTANT: Do not use a silicon sealant to seal the
appliance against the aperture. This will make it
difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced.

Carefully turn the hob back over and then gently lower it into the aperture hole that
you have cut out.

There are holes on the base or the sides of the hob that you can fix the four
brackets to. There are three holes in each one of the brackets.

You should place the bracket on the underneath of the hob, in a position that is
appropriate for the aperture that you have cut out. Using the screws provided, fix
the bracket to the hob. These screws MUST be securely tightened.
Fitting guidelines
The ceramic hob is manufactured to work with three-
phase alternating current (400V3N~50Hz).The voltage
rating of the ceramic hob heating elements is 230V.
Adapting the ceramic hob to operate with one-phase
current is possible by appropriate bridging in the
connection box according to the connection diagram
below. The connection diagram is also found on the
cover of the connection box. Remember that the
connection wire should match the connection type and the power rating of the ceramic
hob.
2
1