HD-EO
Rev.
2
11
3.2
Version 1 Configuration
The HD-EO can support a number of different broadcast formats. The correct
configuration can either be set with a DIP switch or with the GYDA Control
System. The layout of HD-EO is shown in the drawing below with the DIP
switch to the upper left position Look at the labels beside the 8 dip switches
near the release handle in order to find out what hardware version of HD-EO
you have. If the labels match the table below, you have version 1. If they
match the table in chapter 3.1, you have version 2.
Figure 6 - HD-EO version 1 board layout.
DIP switch configuration must be set according to the table below:
Switch # Label Function DIP=ON Function
DIP=OFF Comment
1
D/B
Not in use
Not in use
Always in broadcast
mode
2
E/O
Not in use
Not in use
Always E to O mode
3
RCL
Reclocker ON
Reclocker Bypass
Reclocker mode
4
EQ
Cable equaliser ON
Cable equaliser Bypass Equaliser mode
5 ASI
DVB-ASI
Reclocker
support
SDI 177Mbps Reclocker
support
Select ASI or 177Mbps
support
6
GBE Not in use
Not in use
7
622
Not in use
Not in use
8
OVR Override GYDA control
Config. with DIP switch
GYDA control
Config. with GYDA
Select configuration
from GYDA
All DIP switches are off when pointing towards the release handle.
All clock rates for HD-SDI, SD-SDI and DVB-ASI are automatically configured
by the module itself.
