GYDA-SC
Rev.
4
8
GYDA – Simple Network Management Protocol interface
GYDA can be used as an SNMP agent. This means that all the flashlink
®
modules can be configured and monitored through a higher level third-party
management system.
8.1
SNMP setup
Setup is done through the web interface of GYDA (described in Chapter 7).
This is found under the CONFIG tab.
The following parameters must be set:
-
sysContact
Contact person and contact details for the service person.
-
sysLocation
Where is the system located.
-
SNMP community
Password to access the GYDA SNMP agent
.
-
SNMP trap destination
IP-address of the SNMP manager.
-
SNMP trap community
Password to access the SNMP manager
.
8.2
Audible alarms
Using SNMP is the easiest way to implement audible alarms from GYDA to the
operator’s computer.
All alarms will generate SNMP traps that are fed to the operator’s computer as
configured in Chapter 8.1.
3
Corresponding community setup must be done at the SNMP manager.
21
