NTI VEEMUX VIDEO MATRIX SWITCH
8
CONTROL OPTIONS
The VEEMUX video matrix switch has four methods of control:
•
Front Panel LCD with Keypad
•
Directly via an RS232 Interface
•
Remotely via Ethernet
•
Infrared Remote.
Every unit comes standard with the Front Panel LCD with Keypad, RS232, and Infrared Receiver built in. With the RS232 option,
there are no external devices to be purchased. NTI provides software commands as well as a test program to ensure the RS232
functions properly (see page 10 – RS232 Control).
Front Panel LCD with Keypad Control
The front panel LCD and keypad allow the user to monitor switch status and route any user to any video source on the switch.
When the unit is powered up, each monitor is automatically connected to the video source of its equal number (i.e. monitor 1 to
source 1, monitor 2 to source 2, monitor 3 to source 3, etc.). Along with the routing of the inputs (video sources) to the outputs
(monitors) the keypad and LCD allow the users to configure the RS-232 control interface. The keypad buttons perform the
following functions.
ESC
Escape back to the main display.
0 – 9
Used to enter numbers. ( # )
OUT
Precedes the output number
IN
Used following single digit output entries
ENTER Used following single digit entries and
to select menu options
Display next 4 outputs and their inputs
Display previous 4 outputs and their inputs
MENU See below for description of the Menu.
*
Connects all outputs to one input (i.e. To set all outputs to one input ( * ) + (Input # ) + (ENTER) )
To configure the VEEMUX, use the Menu keys.
Press the
List
button to list your main menu options:
1- Serial
2- Ethernet
3- Standby
4- Save Config
5- Load Config
Use the
Up
and
Down Arrow
keys to scroll through this list.
Use the
Enter
Key to select a menu item.
Press the
Menu
button again to exit the menu.
If, while in a menu, you pause for more than 5 seconds, you will automatically exit the menu.
