Operation
1. When powered ON, the LEDs on the E-SDS-TAA will flash green (approximately once
per second) to indicate the sensor is functioning and in status-ready condition. The LEDs will
illuminate solid red when smoke is detected.
2. Configure the ENVIROMUX to report signals from the connected sensor as smoke detection
sensor alerts. (Refer to ENVIROMUX manual for details on configuration- see also example below.)
When smoke is detected, the switch terminals on the E-SDS-TAA will close to generate
an alert message from the ENVIROMUX.
For maintenance and testing instruction, see the instructions that are included from the sensor
manufacturer with this kit.
Example of sensor configuration in ENVIROMUX
In the event the smoke detector should be placed in alarm condition, it must be power-cycled in order to reset it. To quickly cycle
the power when connected to a Digital Input of an E-16D, go to the sensor status page in the ENVIROMUX WEB interface, and click
on the “Cycle Sensor Power” button. The 12VDC power will be disrupted to the sensor for 5 seconds and then automatically
restored.
Cycle Sensor Power
(E-16D only)
