6
5. Data Report
After power on, the device will immediately send a version packet report and the data report including the temperature,
humidity, PM2.5 and voltage.
The device sends data according to the default configuration before any other configuring.
ReportMaxTime:
RA0716_ RA0716Y is 180s,
R72616 is 900s (subject to original setting)
ReportMinTime: 30s
ReportChange: 0
* The value of the ReportMaxTime should be greater than (ReportType count *Report10). (unit: second)
* ReportType count = 1
Note:
(1) The cycle of the device sending the data report is according to the default.
(2) The interval between two reports must be the MaxTime.
(3) ReportChange is not supported by RA0716_R72616_RA0716Y (Invalid configuration). The data report is sent
according to ReportMaxTime as a cycle (the first data report is the start to the end of a cycle).
(4) Data pocket: PM2.5, voltage, temperature and humidity.
(5) The device also supports the TxPeriod cycle configuration instructions of Cayenne. Therefore, the device can
perform the report according to the TxPeriod cycle. The particular report cycle is ReportMaxTime or TxPeriod
depending on which report cycle was configured last time.
(6) It would take
35 seconds
for the sensor to sample and process the collected value after pressing the button, please be patient.
The device reported data parsing please refer to
Netvox LoraWAN Application Command document
and
Netvox Lora Command Resolver
http://www.netvox.com.cn:8888/page/index
