9
6. Installation
1.
Remove the 3M release paper on the back of the device and
attach the device to the smooth wall (please do not stick it to
the rough wall to avoid falling off after a longtime usage).
Note:
The distance between the magnet and the reed switch must
be less than 2cm.
Wipe the wall surface before installation to avoid dust on
the wall surface that affect the effect of the paste.
Do not install the device in a metal shielded box or other
electrical equipment around it to avoid affecting the
wireless transmission of the device.
The sensor (R311CB) can be applied to the following scenes:
Office building
School
Shopping mall
Villa
The occasions with glass windows or glass doors.
2. If R311CB with the glass sensor detects that the window is
opened (the magnet is separated from the main body) or
closed (the magnet and the main body are closed), the data
will be sent immediately.
3. If the glass breaking vibration triggers the glass sensor, the
data will be sent immediately.
4.
If it detects the battery voltage exceeding the variation value
at MinTime, the data will be sent immediately.
5.
Even if the window status does not change or the no broken
glass is detected, the data will be sent regularly according to
the Max Time.
Note:
when either the main body or the external sensor is in the
open state, the report status1 will be 1.
The report status1 will be 0 only when both the main body
and the external sensor are closed.
When the glass break detector is triggered,
the report status2 will be 1.
R311CB
Magnet
Main Body
Glass Sensor
Installation Diagram
