B
C
D
E
F
G
H
I
J
B
A
Front Panel
A
Dual purpose function
. In normal operation with short presses, it allows you to cycle through input sources for
the connected display . However if this button is pressed and held for 40s it will
reset all network settings
,
returning to factory default. The LEDs on the front of the unit will flash to confirm.
Power Button
Power LED
LED display showing status of input/output, current IP settings, RS-232 settings & EDID input status for each
output. Use the MENU button to scroll through options, using arrows to navigate. Use MENU to return to home
position.
HDMI OP-1 Status
Input Selection OP-1
HDMI OP-2 Status
Input Selection OP-2
Red LED indicates that standby mode is active.
HDMI OP-3 Status
Use any of the input selection buttons after selecting the required output to initiate a manual video switch.
Input Selection OP-3
One button press to initiate output 1 to input 1, output 2 to input 2 etc.
HDMI OP-4 Status
Area to focus direct IR commands
Input Selection OP-4
Use any of the output numbers to select a display, followed by a video input button below, to initiate a manual
video switch.
C
D
E
F
G
H
I
J
Dual purpose function
. In normal operation with short presses, it allows you to cycle through input sources for
the connected display . However if this button is pressed and held for 40s it will
reset all settings
, returning to
factory default. The LEDs on the front of the unit will flash to confirm.
Use any of the output numbers to select a display, followed by a video input button below, to initiate a manual
video switch.
Drivers available at www.netvio.co.uk
5
LED Power On
