Operating the Product
•
Lay the electric blanket flat on the bed. The end with no controller is
the foot end of the blanket.
•
Fix the four corner fasteners of the electric blanket on the four
corners of the bed or mattress with the non-metal belts.
•
Only spread bedsheets on the blanket.
•
Make sure they are laid flat to help conduct heat and so you are
able to see if the blanket is uneven. If everything is flat on the bed,
the electric blanket can be used safely.
Operating the RT8 Controller
•
This controller can control the left and righthand side of the electric
blanket separately.
•
When turning on the controller, the default setting is ‘5’ for both
sides. Press the left/right buttons to adjust the left/right temperature
settings, respectively.
•
The displayed value represents the current settings. The settings
increase from 1-9. The higher the setting, the higher the
temperature. Setting the blanket to 0 means it is not heated.
•
To preheat the blanket, adjust the temperature setting between 6
and 10. The power indicator lamp should glow, and the blanket will
start to heat. Preheating usually takes around 30-50 minutes.
•
The default timing is 10 hours auto-off. You can set a 10 hour auto-
off or a 2 hour auto-off timer, depending on your requirements.
After the timer ends, the indicator for 2 hour auto-off flashes.
•
If using all night or continuously, set the temperature to setting 1.
•
Ensure the controller does not get covered by the quilt, pillows etc.
